

| Parametro | Valore |
|---|---|
| Profondità | 146 mm |
| Larghezza | 61 mm |
| Altezza | 126 mm |
| Altitudine | ≤ 2000 m |
| Isolamento | Reinforced insulation |
| Tipo di prodotto | Relay Module |
| Tipo di montaggio | DIN rail mounting |
| Con componenti | yes |
| Grado di inquinamento | 2 |
| Metodo di connessione | IDC/FLK pin strip |
| Posizione di montaggio | any |
| Note sul funzionamento | For proper use, the specifications of the installation directive (see Downloads) must be observed. For applications or use with third-party products, the specifications, and the safety and warning instructions of the respective third-party manufacturer must also be met. |
| Numero di posizioni | 14 |
| Tensione di sovratensione nominale | 6 kV (1.2/50 μs) |
| Grado di protezione | IP00 |
| Categoria di sovratensione | III |
| Numero di connessioni | 1 |
| Norme/regolamenti | DIN EN 50178: 1998-04 |
| Tipo di commutazione del contatto | Single contact, 1 changeover contact |
| Tensione nominale di ingresso UN | 24 V DC (±10 %) |
| Tensione di isolamento nominale | 260 V |
| Tensione massima di commutazione | 150 V AC/DC (Maximum switching voltage of 230 V AC: the maximum switching voltage of 230 V is only permitted if the same fuse circuit is used. The outputs are not suitable for switching different outer conductors.) |
| Sezione trasversale del conduttore AWG | 24 ... 12 |
| Limitazione della corrente continua | 4 A |
| Corrente di ingresso tipica a UN | 200 mA (200 mA supply / ≤ 20 mA input current per signal) |
| Sezione trasversale del conduttore rigida | 0.2 mm² ... 2.5 mm² |
| Temperatura ambiente (funzionamento) | -20 °C ... 50 °C |
| Sezione trasversale del conduttore flessibile | 0.2 mm² ... 2.5 mm² |
| Collegamento secondo lo standard | IEC 60603-13 |
| Grado di protezione (luogo di installazione) | ≥ IP54 (Installation location) |
Specifiche tecniche e dati di prestazione
Guida di installazione e utilizzo