


| Parametro | Valore |
|---|---|
| Articolo | Specifications |
| Osservazione | Where measurement conditions have not been specified precisely, the conditions used were an ambient temperature of +20 ℃+68 ℉.The values specified above are applied only to the controller. |
| Peso | Net weight : 25 g approx. (excluding connector attached cable), Gross weight : 140 g approx. |
| Dettagli | Controller |
| Display | 4 digits + 4 digits 3-color LCD display (Display refresh rate : 250 ms, 500 ms, 1,000 ms, selectable by key operation) |
| Prodotto | Head-separated Dual Display Digital Pressure Sensor [For gas] |
| Materiale | Enclosure : PBT (glass fiber reinforced), LCD display : Acrylic, Mounting threaded part : Brass (nickel plated), Switch part : Silicone rubber |
| Protezione | IP40 (IEC) |
| Accessori | CN-66A-C2 (Connector attached cable 2 m6.562 ft), Pressure unit label : 1 set |
| Numero di parte | DPC-101 |
| Lunghezza del cavo | Total length up to 100 m328.084 ftis possible with 0.3 mm2, or more, cable. |
| Nome del prodotto | Head-separated Dual Display Digital Pressure Sensor [For Gas] DPH-100 / DPC-100 |
| Uscita analogica | <Analog voltage output>・Output current : 1 to 5 V DC・Zero point : within 1 V ± 0.5 % F.S.(vacuum / positive pressure type)within 3 V ± 0.5 % F.S. (compound pressure type)・Span : within 4 V ± 0.5 % F.S.・Linearity : within ±0.1 % F.S.・Output impedance : 1 kΩ approx.<Analog current output>・Output current : 4 to 20 mA・Zero point : within 4 mA ± 1 % F.S.(vacuum / positive pressure type)within 12 mA ± 1.5 % F.S. (compound pressure type)・Span : within 16 mA ± 1.5 % F.S.・Linearity : within ±0.1 % F.S.・Load resistance : 250 Ω (max.). |
| Numero di prodotto | DPC-101 |
| Tensione di alimentazione | 12 to 24 V DC ± 10 % Ripple P-P 10 % or less |
| Umidità ambientale | 35 to 85 % RH, Storage : 35 to 85 % RH |
| Resistenza agli urti | 100 m/s2acceleration (10 G approx.) in X, Y and Z directions three times each |
| Tipo di pressione | Gauge pressure |
| Metodo di collegamento | Connector |
| Consumo energetico | Normal operation : 960 mW or less (Current consumption 40 mA or less at 24 V supply voltage)ECO mode (STD) : 720 mW or less (Current consumption 30 mA or less at 24 V supply voltage)ECO mode (FULL) : 600 mW or less (Current consumption 25 mA or less at 24 V supply voltage)Excluding the current consumption of sensor head and analog output current |
| Output comparativo | NPN open-collector transistor (2 outputs)・Maximum sink current : 100 mA・Applied voltage : 30 V DC or less(between comparative output and 0 V)・Residual voltage : 2 V or less (at 100 mA sink current) |
| Imposta intervallo di pressione | DPH-101□(Compound pressure) : -199.9 to +199.9 kPa (-1.999 to +1.999 kgf/cm2, -19.98 to +19.98 psi, -1.999 to +1.999 bar, -1510 to +1537 mmHg, -59.4 to +60.5 inHg)DPH-102□(Positive pressure) : -1.050 to +1.050 MPa (-10.71 to +10.71 kgf/cm2, -152.2 to +152.2 psi, -10.50 to +10.50 bar)DPH-103□(Vacuum pressure) : +101.3 to -101.3 kPa (+1.033 to -1.033 kgf/cm2, +14.70 to -14.70 psi, +1.013 to -1.013 bar, +760 to -760 mmHg, +29.9 to -29.9 inHg)(Note) : It changes automatically according to the connected pressure sensor head. |
| Temperatura ambiente | -10 to +50 ℃+14 to +122 ℉(No dew condensation or icing allowed), Storage : -10 to +60 ℃+14 to +140 ℉ |
| Indicatore di funzionamento | Orange LED (Comparative output 1 operation indicator, comparative output 2 operation indicator : Lights up when each comparative output is ON) |
| Intervallo di pressione nominale | DPH-101□(Compound pressure): -100.0 to +100.0 kPa,DPH-102□(Positive pressure): 0 to +1.000 MPa,DPH-103□(Vacuum pressure): 0 to -101.0 kPa(Note) : It changes automatically according to the connected pressure sensor head. |
| Resistenza alle vibrazioni | 10 to 500 Hz frequency, double amplitude 3 mm0.118 inor maximum acceleration 196 m/s2, in X, Y and Z directions for two hours each (when panel mounting bracket is mounted : 10 to 150 Hz frequency, double amplitude 0.75 mm0.030 inor maximum acceleration 49 m/s2, in X, Y and Z directions for two hours each) |
| Resistenza di isolamento | 50 MΩ, or more, with 500 V DC megger between all supply terminals connected together and enclosure |
| Resistenza alla tensione | 1,000 V AC for one min. between all supply terminals connected together and enclosure |
| Ingressi: ingresso testa sensore | Input voltage range : 1 to 5 V DC (over rated pressure range) |
| Tensione di alimentazione della testa del sensore | Same as supply voltage |
| Caratteristiche della temperatura | Within ±0.5 % F.S. (ambient temperature range based on +20 ℃+68 ℉) |
| Output comparativo: isteresi | Minimum 1 digit (variable)(however, 2 digits when using psi unit) |
| Conformità alla direttiva sulla marcatura CE | EMC Directive, RoHS Directive |
| Output comparativo:Modalità di output | EASY mode / Hysteresis mode / Window comparator mode |
| Output comparativo:Ripetibilità | With vacuum / positive pressure type connected : within ±0.2 % F.S. (±2 digits)With compound pressure type connected : within ±0.2 % F.S. (±4 digits) |
| Output comparativo: tempo di risposta | 0.5 ms, 1 ms, 2.5 ms, 5 ms, 10 ms, 25 ms, 50 ms, 100 ms, 250 ms, 500 ms, 1,000 ms, 5,000 ms, selectable by key operation |
| Display: intervallo di pressione visualizzabile | Vacuum pressure : +5.1 to -101.3 kPa,Positive pressure : -0.050 to +1.020 MPa,Compound pressure : -101.3 to +105.0 kPa |
| Output comparativo: operazione di output | NO / NC, selectable by key operation |
| Uscita comparativa: protezione da cortocircuito | Incorporated |
| Ingressi: ingresso esterno (funzione di riferimento automatico/funzione di regolazione dello zero remoto) | ON voltage : +0.4 V DC or lessOFF voltage : +5 to +30 V DC, or openInput impedance : 10 kΩ approx.Input time : 1 ms or more |
Specifiche tecniche e dati di prestazione
Guida di installazione e utilizzo